You are here: Home » News » Common faults and solutions of the filling head of aerosol filling machine

Common faults and solutions of the filling head of aerosol filling machine

Views:0     Author:Site Editor     Publish Time: 2021-03-08      Origin:Site

The aerosol filling machine is an equipment used to fill aerosol products. The core components of the equipment are composed of a filling machine, an inflator, and a sealing machine. Now aerosol products can be seen everywhere in our lives. The aerosol filling machine has been applied to many industries, but the aerosol filling machine equipment will inevitably have some problems after being used for a long time. Today, the aerosol filling machine manufacturer tells you the common faults of the aerosol filling machine inflation head and The solution, you can prescribe the right medicine.
The following are common faults and solutions for the inflation head of aerosol filling machine:

Common failures of aerosol filling machine inflator head one:

The measurement accuracy is inaccurate when inflating. Reason analysis: the compressed air pressure is unstable, and the seal in the metering cylinder is damaged. Solution: check and repair the air compressor; replace the seals.

Common failures of the aerosol filling machine inflator head two:

The aerosol filling machine leaks air in the filling head during filling. Reason analysis: the rubber gasket at the bottom of the inflation nozzle is damaged, and the ejector pin of the inflation nozzle is not well lubricated. Solution: Replace the rubber gasket; add lubricating oil appropriately at the top tip.
Three common failures of aerosol filling machine inflator head:
When there is no filling, the inflation head leaks. Reason analysis: there is debris on the PTFE gasket in the inflatable head or the gasket is damaged; the sealing ring of the inflatable head is damaged. Solution: Remove debris or replace gaskets or seal rings.
Four common failures of aerosol filling machine inflator head:
The filling head of the aerosol filling machine does not reset when filling and filling. Cause analysis: The throttle adjustment elbow on the small cylinder of the charging head is adjusted too small or closed tightly, the plate of the charging head is too high, the foot valve is blown, and the gas metering cylinder signal valve is blown. Solution: increase the air-inflating head and adjust the elbow, adjust the height of the table, replace the foot valve, and replace the signal valve.
Five common faults of aerosol filling machine inflator head:
Step on the foot valve, the inflation head will be reset when it is not inflated or the amount of inflation is low after the inflation head is lowered, and the cylinder will reset without triggering the signal valve, and the gas metering cylinder will not operate. Reason analysis: reset switch or signal valve gas. Solution: If there is a slight air leak, cut a small hole in the air pipe at the air outlet of the switch or signal valve. If it still can't be solved, replace the reset switch or signal valve.

Shandong Finetry Machine Co. LTD.founded in 2003,
Iocated in Shandong province,China.We are an 
enterprise specializing in the research and.....

Quick Links

Product Center

 
 +86-0539-7702016
Phone Number : +86 13341277577 
Wechat & whatsapp:+86 13341277577
             finetrymachine@gmail.com
 

Contact us
Copyright © 2019 - 2021 Shandong Finetry Machine Co. LTD.