Views:0 Author:Site Editor Publish Time: 2021-12-29 Origin:Site
The automatic insecticide spray filling machine is a machine and equipment for the production of aerosols. Aerosols are more common in life. Common sunscreen sprays, medical sprays, mosquitoes, etc., are all aerosols. . The automatic aerosol filling machine is a filling equipment for the production of aerosols. The automatic aerosol filling machine provided by Meida has the advantages of excellent performance, convenient operation and stable use.
The automatic aerosol filling machine consists of three parts: liquid filling machine, sealing machine and inflator. The equipment is powered by an air compressor and does not require electricity.
1. Adjust the air source pressure of the main engine.
Open the hand slide valve in front of the air source, pull up the pressure regulating knob on the air source, and turn it clockwise to increase the pressure. Rotate counterclockwise, the pressure drops. Adjust to the required pressure (normally to 0.6-0.7MPa), press the pressure regulating knob to lock it.
2. Adjust the sealing diameter and sealing depth
Turn on the hand slide valve in front of the air source of the main engine and the sealing knob switch on the panel, take a valve and press it in the sealing head with your fingers, step on the foot valve, take out the valve, and measure the outer diameter and height of the sealing. Generally, iron cans are equipped with iron valves, and the outer diameter of the seal is controlled within 27.9mm~28.0mm. The sealing height is controlled within 5.1mm-5.2mm.
3. Adjust the height of the host table.
First press the top of the sealing machine to make the sealing cylinder go down to the end. At this time, the bottom of the sealing cylinder will press the copper-colored top pin on the sealing signal valve. Then place an aerosol can that needs to be filled in the guide rail directly below the sealing head.
Fourth, adjust the position of the filling head and the filling head.
Close the hand slide valve in front of the air source of the main engine, place an aerosol can under the sealing machine, press the top of the sealing machine by hand, make the sealing head press the aerosol can, keep the position of the aerosol can, and then place the aerosol in the guide rail The canister so that it is next to the aerosol canister under the sealing head.
5. Metering adjustment of liquid filling machine and inflator.
The height of the positioning piston of the metering cylinder cylinder can be adjusted by rotating the adjustment knob on the top of the metering cylinder, thereby changing the stroke of the metering cylinder piston to change the filling measurement size.
6. Debugging of booster pump.
Open the hand slide valve in front of the air source of the booster pump, and the piston will move up and down when the booster pump is idling, and there will be a "boom" reversing exhaust sound.
The above is the process and method of adjusting the aerosol automatic filling machine, I hope it can help everyone.