Views: 0 Author: Site Editor Publish Time: 2020-04-07 Origin: Site
The filling machine is a packaging machine. It is widely used in our lives and will be used frequently. However, due to long-term work, it will wear some. The following is a brief introduction to some knowledge of filling machine care. We must regularly check some machine parts, such as half a month or once a month.
The inspection components include: worm gears, worms, bolts on the lubricating block, bearings and other moving parts, to see if these parts rotate flexibly and wear out. If defects are found, they should be repaired in time, and they should not be used reluctantly. When installing, choose a dry and clean room for use. Try not to use them where the atmosphere contains acids and other corrosive gases circulating into the body.
After using the machine, it should be cleaned and installed for the next use. The drum moves back and forth during operation. Adjust the screw on the front bearing pawl to the correct position. If the gear shaft moves, adjust the screws on the back of the bearing frame to the proper position, adjust the clearance so that the bearing does not emit any noise, and tighten the hand pulley properly.
If it is too tight or too loose, the machine may be damaged. Then, if the packaging equipment is not used for a long time, the entire body of the filling machine must be cleaned, and the smooth surface of the parts should be coated with anti-rust oil and covered with cloth. If the equipment will not be used for a long time, check whether the components are normal before use.